[mythtv-commits] Ticket #9191: Channel switching doesn't work with cx18 driver

MythTV mythtv at cvs.mythtv.org
Sun Nov 14 18:31:15 UTC 2010


#9191: Channel switching doesn't work with cx18 driver
------------------------------------+---------------------------------------
 Reporter:  Artem Astafyev          |           Owner:         
     Type:  defect                  |          Status:  new    
 Priority:  minor                   |       Milestone:  unknown
Component:  MythTV - General        |         Version:  0.23.1 
 Severity:  medium                  |      Resolution:         
 Keywords:  cx18 SetInputAndFormat  |   Ticket locked:  0      
------------------------------------+---------------------------------------

Comment (by anonymous):

 Replying to [comment:5 danielk]:
 > Please try adding: "requires_special_pause = true;" on line 437, before
 the VERBOSE(VB_RECORD...

 danielk,

 You are likely correct.  The problem is at least here:

 http://svn.mythtv.org/trac/browser/trunk/mythtv/libs/libmythtv/mpegrecorder.cpp#L430

 The cx18 driver is very much like the ivtv driver.  An "else if (driver ==
 "cx18")" block is probably needed there.  The cx18 driver need the special
 pause, uses v4l2, has vbi, but I don't think needs the buggy vbi boolean
 set (I'm not sure though).

 Regards,
 Andy

-- 
Ticket URL: <http://svn.mythtv.org/trac/ticket/9191#comment:6>
MythTV <http://www.mythtv.org/>
MythTV Media Center


More information about the mythtv-commits mailing list