[mythtv] [PATCH] (mythvideo) per-directory player command

[Michael T. Dean]

John Patrick Poet wrote:

> I have some videos which are 16:9 and some which are 4:3.  These 
> videos may be mpegs or avis.
>
> This patch causes mythvideo to look for a ".mythvideo" file in the 
> directory where the video file is located.  If that file exists, the 
> content will be used as the player command instead of the default.
>
> For example, in the directory where I keep my 4:3 video files, I have 
> a .mythvideo file which contains:
>
> xrandr -s 640x480;mplayer -quiet -monitoraspect 4:3 -framedrop 
> %s;xrandr -s 888x500
>
> This changes my output resolution to 640x480, runs mplayer with a 4:3 
> aspect, and then switched back to my normal 888x500 (16:9) "menu" 
> resolution when mplayer exits.
>
> There may be a better (more efficient) way to achieve this 
> functionality, but this was a simple change.

Both MPlayer and xine support on-the-fly resolution switching using the 
X VidModeExtension.  When using the built-in xvidmode support, the 
player will determine the best video mode to use (of all the available 
modes you have configured in your XF86Config (or xorg.conf) file) based 
on resolution and aspect ratio (and refresh rate?) of the video.  If 
using Xv video out, the video will then be scaled to full-screen for the 
selected resolution in the event none of the video modes is an exact 
match for the video's resolution.

To have mplayer switch the resolution specify the "-vm" option on the 
command-line (works with "-vo xv", in spite of what the man page 
implies).  To have xine switch the resolution, specify

gui.use_xvidext:1

in the ~/.xine/config file (can be specified through the GUI at the 
bottom of the "gui" tab of the xine setup dialog--check the box "use 
XVidModeExtension when switching to full screen").

Unfortunately, xine doesn't set the resolution back to the pre-switch 
resolution, but MPlayer does.

Mike