[mythtv] firewire mpeg2ts input

DavidB mythtv at TheBlains.net
Wed Feb 2 19:28:29 UTC 2005


Jim,

First off, Great Work!

I am trying to get the firewire working and have not had any success. Here
is what I have done to this point:

1) Downloaded libraw1394 version 1.1.0 source, compiled and installed.
2) Pulled down the trunk source for libiec61883 revision 49, compiled and
installed.
3) Re-compiled 6200ch to use new libraw1394 and tested.  (I have been using
this to change channels for a few months)
4) Pulled down current CVS as of 11:00am today. Compiled, installed, and ran
setup.  
5) Configured a new Capture Card and selected port 0, node 1 (used gscanbus
and 6200ch -v to get values)

When I manually schedule a program for a local channel I get the following
in the log file:
	
2005-02-02 14:04:36.657 FireWire: Initializing Port: 0, Node: 1, Speed:
100Mbps
libiec61883 warning: Overlayed connection on channel 0.
You may need to manually set the channel on the receiving node.
2005-02-02 14:04:36.661 FireWire: Created Channel: 0, Bandwidth Allocation:
0
2005-02-02 14:04:36.661 FireWire: Changing Speed 200Mbps -> 100Mbps
2005-02-02 14:04:51.656 Firewire: No Input in 15 seconds [P:0 N:1] (select)

Is there anything that I can use to determine if everything is configured
correctly? 

As a note: I am doing all this work through an ssh session so I can only
test by scheduling a recording through mythweb.

Any help would be appreciated. Thanks,

David




More information about the mythtv-dev mailing list