[mythtv] [mythtv-commits] mythtv commit: r10201 - in trunk/mythtv by danielk
Ed W
lists at wildgooses.com
Fri Jun 16 13:40:54 UTC 2006
> I'm thinking of an example where say BruteFIR was used via JACK for normal
> stereo but that was bypassed for AC3/DTS output (which you don't want to
> pass through a FIR - unless you decode and reencode it!). Does this not
> make sense? I hope it does, because that's what I'm considering.
>
Oh, I see.
Err, well yes I guess then that would work, but it's not a config I can
easily test/develop.
Have you considered using Brutefir + 5 analogue/digital outputs going
into your receiver? If you are really pushed then you can get a Jack
plugin to re-encode to AC3 once you have run it through Brutefir
This allows you to use BF to do all your bass management and also room
correction on all 5 channels. This is what I do in my setup, but what I
do at the end is to spit everything out in analogue to a bunch of high
power amps which are wired up directly to the PC. I guess you have seen
my system though?
http://www.duffroomcorrection.com
Good luck
Ed W
More information about the mythtv-dev
mailing list