[mythtv] [mythtv-commits] Ticket #9297: Cannot switch to or watch HD Channels with firewire STB in LiveTV, but recording from the same channels works fine
Michael T. Dean
mtdean at thirdcontact.com
Sun Nov 28 20:53:49 UTC 2010
On 11/28/2010 01:19 PM, Erik Sejr wrote:
> On 11/28/2010 6:45 AM, Michael T. Dean wrote:
>> On 11/28/2010 02:26 AM, MythTV wrote:
>>> #9297: Cannot switch to or watch HD Channels with firewire STB in
>>> LiveTV, but
>>> recording from the same channels works fine
>>> ---------------------------------------------------+------------------------
>>>
>>> Reporter: Erik Sejr<esejr@…> | Owner:
>>> Type: Bug Report |
>>> Status: infoneeded_new
>>> Priority: minor |
>>> Milestone: unknown
>>> Component: MythTV - General |
>>> Version: Unspecified
>>> Severity: medium | Resolution:
>>> Keywords: | Ticket
>>> locked: 0
>>> ---------------------------------------------------+------------------------
>>>
>>>
>>> Comment (by Erik Sejr<esejr@…>):
>>>
>>> Replying to [comment:1 mdean]:
>>> > dup of #9177 ?
>>>
>>> I'm not sure, the problem sounds very similar, but there's no
>>> mention in
>>> that ticket of the odd channel changing behaviour. I don't think I can
>>> attempt the workaround the reporter of #9177 has in his ticket as I
>>> only
>>> have a single tuner at my disposal. I have found no way to work around
>>> this beyond simply setting the show to record, then going and
>>> watching the
>>> recording.
>>>
>>> I will admit that I did not see #9177 while I was looking at some
>>> of the
>>> other bugs.
>> If you set your starting channel to an HDTV channel (in mythtv-setup),
>> can you start Live TV and successfully change to other HDTV channels,
>> and after that to SDTV channels.
>>
>> Thanks,
>> Mike
> Hi Mike,
> I'm afraid not. I did the steps below in order:
>
> 1. Shutdown the frontend
> 2. Stop the backend
> 3. Go into mythtv-setup, change the initial channel to 700 (an HD Channel)
> 4. Restart the backend - STB is sent "7" "0" "0" at this time and
> changes channels successfully
> 5. Startup the frontend
> 6. Try to watch LiveTV - The STB is sent "0" "0" "3" as soon as I select
> live TV and returns to the SD channel (003).
> 7. LiveTV Starts successfully on the SD channel. Any attempt to change
> to a HD channel causes the same bug as described in the ticket.
Do you have a "Preset tuner to channel" specified with a value of 3?
It's somewhere in mythtv-setup.
Mike
More information about the mythtv-dev
mailing list