[mythtv-users] Re:Connection Setup (cords)
Sam Steele
chip at c99.org
Fri Apr 18 17:42:49 EDT 2003
Did you remember to select line in for recording in alsamixer?
-Sam
On Fri, 2003-04-18 at 16:31, Bruce Markey wrote:
> Brad Atkins wrote:
> > Hey,
> >
> > I tried that and got sound from the line in. Then i mute it (and turn
> > everything else up) and run aplay /dev/dsp and I don't hear anything.
> >
> > I have a cable running from my capture card to my sound card Line In. I
> > set Line In as the capture source too.
> >
> > This card is full duplex capable (it states that in /var/log/message).
> >
> > Any other ideas as to what is up with the sound?
>
> The fact that you got sound from the line in narrows the
> problem. So either it isn't getting recorded or played
> back correctly.
>
> For record, either there is a mixer that affects the capture
> gain that needs to ge unmuted and turned up or there is a
> driver or hardware problem. Try "record" which is one of the
> executables with xawtv. You should see the right/left levels
> move if capture is setup and working correctly.
>
> For playback it may be that /dev/dsp is not the correct
> device. Try /dev/dsp0, dsp1, dsp2, dsp3. When you use aplay
> on a device file where there really is a device you will see:
>
> Playing raw data '/dev/dspN' : Unsigned 8 bit, Rate 8000 Hz, Mono
> xrun!!!...
>
> Another problem would be if PCM was muted or not turned up
> but you mentioned playing other wav files so I doubt that
> would be the problem.
>
> -- bjm
>
>
>
>
>
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at snowman.net
> http://lists.snowman.net/cgi-bin/mailman/listinfo/mythtv-users
More information about the mythtv-users
mailing list