[mythtv-users] How do I select "new command set" for my RCA
receiver?
John Klimek
jmk396 at psu.edu
Wed Jun 4 13:04:19 EDT 2003
D'oh. I figured it out.
However, the commands (from the utility) are ALL working. However all of
the commands "timeout" everytime.
And I'm still wondering if MythTV supports these "new command set"'s...
----- Original Message -----
From: "John Klimek" <jmk396 at psu.edu>
To: "Discussion about mythtv" <mythtv-users at snowman.net>
Sent: Wednesday, June 04, 2003 11:57 AM
Subject: [mythtv-users] How do I select "new command set" for my RCA
receiver?
> I'm sorry for so asking so many questions...
>
> There shouldn't be too many more, and thanks to everybody who has helped
me
> so far.
>
> I've built my Serial-to-RJ11 cable and it's not really working. When I
load
> up the DirectTV Serial Control Utility and press the "Power On" button, my
> receiver powers on but then it turns back off. If I then manually turn on
> my receiver, it will be reset and it will search for the satellite signal.
>
> After reading on www.pcmx.net/dtvcon, it says that for my receiver I must
> select "New Command Set" for the system menu. Where can I do this?
>
> My receiver is an RCA DRD430RG.
>
> Also, I'm testing this with the windows program "DirectTV Serial Control
> Utility". Does MythTV have support for these "new command set" RCA units?
>
> Again, I'm really sorry for so many questions. I did search the
> mailing-list archives for "new command set" and nothing was found...
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at snowman.net
> http://lists.snowman.net/cgi-bin/mailman/listinfo/mythtv-users
>
More information about the mythtv-users
mailing list