[mythtv-users] How to get interlaced PAL TV out on Nvidia?
Clyde Stubbs
clyde at htsoft.com
Sat Nov 8 17:59:29 EST 2003
On Sat, Nov 08, 2003 at 01:11:18PM +0000, Gavin Hamill wrote:
> How about defining a mode for 702x576i (or 720x576i or 768x576i - I
> can't rememebr the required dimension :)
Tried that (various resolutions up to 800x600) - basically any mode
that requires a horizontal scan rate of less than 30kHz is chucked out
by X at startup with the bad clock/mode/interlace message. Even if
I try 320x240 it sets that up as doublescan with a horizontal
rate of 31.5kHz. I have not found any mode acceptable to the driver
with a scan rate less than 30 - yet I know the hardware will do it
because its default state on power up works. And I have seen example
modelines that others have used in various how-to's that set up
rates of 15kHz or so.
My next step is to trawl the X source to see if there is some
hardwired limitation in 4.3.
Clyde
--
Clyde Stubbs | HI-TECH Software
Email: clyde at htsoft.com | Phone Fax
WWW: http://www.htsoft.com/ | USA: (408) 490 2885 (408) 490 2885
PGP: finger clyde at htsoft.com | AUS: +61 7 3552 7777 +61 7 3552 7778
---------------------------------------------------------------------------
HI-TECH C: compiling the real world.
More information about the mythtv-users
mailing list