[mythtv-users] IR-200L Help

[Cory Megitt]

Can anyone offer any advice as to how to get change_channel.csh to actually
change the channel or elaborate on what I might be doing wrong?
 

-----Original Message-----
From: mythtv-users-bounces at mythtv.org
[mailto:mythtv-users-bounces at mythtv.org] On Behalf Of MythTV
Sent: Monday, August 09, 2004 11:17 PM
To: Discussion about mythtv
Subject: [mythtv-users] IR-200L Help

I managed to run: remote_irrecord --device=/dev/remote filename and the dots
appear so I know that the IR Blaster is receiving signals from the
Scientific Atlanta remote.
It generated a conf file with the following data, however, when running
change_channel.csh 13 as per the directions, it does not change the channel.
A new PID number gets generated though.

Here's the output of the file remote_irrecord generated.

begin remote
 


  name  filename
  bits           23
  flags SPACE_ENC|CONST_LENGTH
  eps            30
  aeps          100
 


  header       3329  3350
  one           832  2510
  zero          832   855
  gap          100299
  toggle_bit      0
 


 


      begin codes
      end codes
 


end remote
 


-------------
 


This data differs slightly from my /etc/remoted.conf file.

begin remote
 


  name   SA2000
  flags CONST_LENGTH|RAW_CODES
  eps            30
  aeps          100
 


  ptrail          0
  repeat     0     0
  gap    100240

Should I adjust the remoted.conf file to accomodate the additional info that
was created?

I am using a Scientific Atlanta E2050ER1 remote, along with a 3200 model
receiver.
_______________________________________________
mythtv-users mailing list
mythtv-users at mythtv.org
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users