[mythtv-users] Lirc not working with PVR-250
John Johnson
johnatl at mac.com
Tue Dec 28 02:15:25 UTC 2004
Thanks for the reply!
I finally found out about irrecord. Part of the file created is
attached. As you can see, quite a few of the codes are the same. It
also grumbled about the toggle bit being invalid, no matter what speed
I pressed a button at the end.
Thanks for any help.
Regards,
JJ
begin remote
name hauppauge-2.conf
bits 13
eps 30
aeps 100
one 0 0
zero 0 0
gap 199986
toggle_bit 0
begin codes
Go 0x00000000000017BB
Off 0x00000000000017BB
Tv 0x0000000000001FBD
Videos 0x000000000000179C
Music 0x0000000000001799
Pictures 0x0000000000001799
Guide 0x000000000000179B
Radio 0x000000000000179B
On 27-Dec-2004, at 06:57, Niels den Otter wrote:
> John,
>
> On Sunday, 26 December 2004, John Johnson wrote:
>> I'm running KnoppMyth R4V5, and can't get even a twitch from the
>> remote. I
>> can see it is emitting IR using my camcorder. I can occasionally get
>> output by using 'hexdump /dev/lirc' and pressing remote buttons
>> repeatedly. Can't get irw to print anything, just sits there. Ran
>> lircmd,
>> no response to the remote in X. I have the grey Hauppauge! remote. The
>> number buttons are at the bottom, as are the colored buttons.
>>
>> I'm about to jump into recompiling lirc, but not sure if that will
>> help.
>> Any suggestions are greatly appreciated!
>
> Sounds like you are using an incorrect lircd.conf for your remote. Can
> you
> try irrecord to see what it generates and compare that to your
> lircd.conf
> file?
>
>
> -- Niels
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
More information about the mythtv-users
mailing list