[mythtv-users] Re: Pvr-350 - Do the menus work on tvout
john.p.harvey at btinternet.com
Wed Dec 29 21:43:40 UTC 2004
I don't have anything in modules.conf.
When playing tv back myth writes to the ivtv frame buffer directly to draw
the menus and OSD (except for the programme guide which is drawn by X).
You should be able to manually load the frame buffer support with
Then you should be able to get the menus and OSD to work. If however the
rest of the OSD is displayed (pause/play position stuff and channel change
information) then the problem is likely to be something different.
> -----Original Message-----
> From: mythtv-users-bounces at mythtv.org [mailto:mythtv-users-
> bounces at mythtv.org] On Behalf Of Don Brett
> Sent: 29 December 2004 21:20
> To: MythTv
> Subject: [mythtv-users] Re: Pvr-350 - Do the menus work on tvout
> Thanks for the replies.
> John at Netdirect - I was talking about the "Use PVR250/350 output" in
> Mythfrontend's setup, so I'll look at you instructions a bit later. I
> was following that thread earlier until I realized it was FC related.
> It seems that every time I attempt to apply FC instructions to
> Slackware, I get lost (but maybe the X parts still apply).
> John.P.Harvey at BtInternet - Which driver and firmware are you using?
> Also, could you post the ivtv and lircd portions of your modules.conf?
> distro - Slackware 9.1
> Kernel - 2.4.27
> driver - ivtv-0.2.0-rc3a
> firmware - pvr_220.127.116.1168_inf.zip
> alias char-major-81 videodev
> alias char-major-81-0 ivtv
More information about the mythtv-users