[mythtv-users] PVR-250 remote with home built reciever
mythtv2 at matter.net
Wed Feb 18 17:24:50 EST 2004
It works with a homebrew IR, I'm using it that way now. As you said, it
uses rc-5 which means you need a special lircd.conf file. Go here:
Look at item #3 under software setup section. I can also send you my
lircd.conf file if you like (when I get home).
> the Hauppauge remote uses the rc5 protocol. so to use this, you would
> to build a receiver that recognizes it. Frankly I do not know if a
> serial receiver will work with this remote, I have never tried. perhaps
> is just a setting in the lirc Makefile to have rc5 support in the binary
> the serial device.
> good luck
> John Timon
> Unix like TeePee no windows, no gates, Apache inside.
> -----Original Message-----
> From: Tom Jaeger [mailto:mail at networksinstalled.com]
> Sent: Wednesday, February 18, 2004 3:32 PM
> To: mythtv-users at mythtv.org
> Subject: [mythtv-users] PVR-250 remote with home built reciever
> I am going to be building a IR reciever from
> I have a backend system setup now and a second frontend computer to watch
> shows on (long story but the pvr-250 crashes if i watch a recording while
> the card is recording).
> Can I use my silver PVR-250 remote with this reciever or do I need to
> purchase one?
> I have googled and searched lirc and here but no luck.
> Tom J
> mythtv-users mailing list
> mythtv-users at mythtv.org
More information about the mythtv-users