[mythtv-users] Fedora and ATrpm configuration

[Axium Computer Services]

Gary Huntress wrote:

>Yes I am a n00b and I should have mentioned in my first message that I did
>read that.  I tried the newer kernel with:
>
>     apt-get install kernel#2.4.22-1.2135.nptl_27.rhfc1.at.i586.rpm
>  
>

cut of the .i586.rpm so it reads:

apt-get install kernel#2.4.22-1.2135.nptl_27.rhfc1.at





>and that gives the same error "Couldn't find package..."
>
>So I'm now pretty positive that I have a configuration problem with apt-get
>and I will take this to the appropriate group.
>
>Thanks
>
>----- Original Message -----
>From: "Scott Francis" <scott.francis at newisys.com>
>To: "Discussion about mythtv" <mythtv-users at mythtv.org>
>Sent: Friday, January 02, 2004 2:32 PM
>Subject: RE: [mythtv-users] Fedora and ATrpm configuration
>
>
>Remember that Jarod's instructions also say to check out the website to find
>the latest kernel :)
>
>Go to http://atrpms.physik.fu-berlin.de/dist/fc1/kernel/
>
>And you'll see the kernel should be:
>
>kernel-2.4.22-1.2135.nptl_27.rhfc1.at.i586.rpm  and
>
>kernel-source-2.4.22-1.2135.nptl_27.rhfc1.at.i386.rpm
>
>Hope that helps.  Heheh..I just wish I could get my PVR350 working :(
>
>Scott
>
>-----Original Message-----
>From: mythtv-users-bounces at mythtv.org
>[mailto:mythtv-users-bounces at mythtv.org]On Behalf Of Gary Huntress
>Sent: Friday, January 02, 2004 1:19 PM
>To: Discussion about mythtv
>Subject: [mythtv-users] Fedora and ATrpm configuration
>
>
>Hi,
>
>Again, this is only peripherally related to mythtv and ivtv but I know a lot
>of people use apt-get on Fedora to install, and I'm hoping someone can find
>what I'm doing wrong.
>
>I'm trying to install Mythtv via Jarod Wilsons HOWTO
>(http://wilsonet.com/mythtv/). I have a fresh installation of Fedora FC1 and
>I've been following along step by step ok until I got to step 7 "Get and
>install custom ATrpms kernel". When I run:
>
>    # apt-get install kernel#2.4.22-1.2129.nptl_24.rhfc1.at
>kernel-source#2.4.22-1.2129.nptl_24.rhfc1.at
>
>I get:
>
>    Couldn't find package kernel#2.4.22-1.2129.nptl_24.rhfc1.at
>
>My first thought is that it's a config problem so I went to
>/etc/apt/servers.list and found:
>
># ATrpms for Red Hat Linux 9
># Possible sections: at-stable, at-good, at-testing, at-bleeding
>rpm http://apt.physik.fu-berlin.de redhat/9/en/i386 at-testing
>#rpm-src http://apt.physik.fu-berlin.de redhat/9/en/i386 at-testing
>
>Which I believe are correct (as per
>http://atrpms.physik.fu-berlin.de/install.html)
>
>I'm sure it's me and not Jarod's directions. Can anyone tell me what I've
>screwed up? I'll slick this FC1 installation if I have to! I'm getting
>impatient (actually my wife is) now that I'm on my second system and
>purchased second TV card!
>
>Any suggestions that lead to a solution will be greatly appreciated!
>
>Gary
>
>  
>