[mythtv-users]
mythfilldatabase ran, but did not insert any new data
Gary Lerhaupt
gary at lerhaupt.com
Tue Jun 1 23:09:48 EDT 2004
I followed the guidelines to transition from xmltv to datadirect. I set
up my account, redid the setup and mythfilldatabase performs (or seems
to perform) as I would expect it. However, I don't get any guide
information, and from status, it tells me that
mythfilldatabase ran, but did not insert any new data into the Guide.
This can indicate a potential grabber failure.
Interestingly, when I go into myth setup and look at the channel editor,
it does not show any channels there. As well, though this is probably
unrelated, I recently started getting segfaults from klipper whenever
going into init 5. Further, I can no longer even change the channel and
am stuck permanently on ABC (channel 3). Each time I try to change the
channel, it just shows the info as (-1440 minutes). If I bring up the
guide, it is completely empty (doesn't even say Unknown) and if I try to
move the cursor, the frontend completely dies.
I have updated and recompiled as of cvs today. I have done a lot of
searching through the list and have not seen anyone else report similar
behavior. Any thoughts?
Thanks,
Gary
More information about the mythtv-users
mailing list