[mythtv-users] DVB#0 ERROR on mythbackend startup
Ivan A. Beveridge
ivan at dreamtime.org
Wed Jun 30 18:59:25 EDT 2004
On Wed, Jun 30, 2004 at 05:57:58PM -0400, Jason Lixfeld wrote:
> Ok, so I went into channel editor and edited channel 198, put in the
> Symbol Rate (20000000), set polarity to Vertical, set VPID and APIDs to
> 5410 and 5411, respectively and set the frequency to 12224000. All
> these settings I got off here: http://global-cm.net/MPEGlistDBSN1.html
> When I start mythbackend now, I get this:
> $ mythbackend
> Starting up as the master server.
> 2004-06-30 17:54:36 mythbackend: MythBackend started as master server
> 2004-06-30 17:54:36 DVB#0 Using DVB card 0, with frontend
> STV0299/TSA5059/SL1935 based.
> Resetting slot 0...ok.
> Resetting slot 1...ok.
> 2004-06-30 17:54:37 DVB#0 CAM - Initialized successfully.
> 2004-06-30 17:54:37 DVB#0 WARNING - Your frequency setting (12224000)
> is out of range. (min/max:950000/2150000)
Have you tried using szap / scan, etc - the dvb tools? They would be
your best bet to check channels and get details, rather than using
I had the same error when using dvb-t in the UK. I noticed I miscounted
the number of digits when entering the details from "scan" output into
mythtv. It doesn't look to be the case for you. Have you tried googling
for another mention of the satellite (or your location) with respect to
DVB / linux? IIRC you need the frequency/polarity for scan to tune in
and then get all PIDs.
Ivan Beveridge <ivan at dreamtime.org>
More information about the mythtv-users