[mythtv-users] Difference in an Hauppage PVR-250 and PVR-350.

[Paul K.]

  I'm not sure of all the differences, but I think you go it. But the TV-OUT
is a 9pin cable set with s/video and composite jacks. The second coax
connector you see is for the FM radio antenna. But, yeah - It both
encodes/decodes via hardware.

Paul

----- Original Message ----- 
From: "Andrew Short" <ashort at wingedwheel.net>
To: <MYTHTV-USERS at mythtv.org>
Sent: Friday, March 05, 2004 10:27 PM
Subject: [mythtv-users] Difference in an Hauppage PVR-250 and PVR-350.


>
> Trying to get a hold on the differences between the two:
>
> >From what I can tell:
>
> 1.  The PVR-350 has a supported, hardware MPEG-2 decoder attached to a
> coax OUT port.  This means that not only can the 350 encode with minimal
> CPU impact, it can decode as well with minimal CPU impact.
>
> 2.  The PVR-350 lists for $70 more.
>
>
> Are these the ONLY differences between the PVR-350 and PVR-250?
>
> Is this an accurate and full account?
>
> --
> Andrew Short                                      ashort at wingedwheel.net
> CCIE #6641                                               Colossians 3:23
> "With  sufficient  thrust,  pigs  fly  just  fine.   However,   this  is
> not  necessarily  a  good  idea"   -   rfc1925,  paragraph  2,  part  3a
>


----------------------------------------------------------------------------
----


_______________________________________________
mythtv-users mailing list
mythtv-users at mythtv.org
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users