[mythtv-users] Script after recording
Travis
travs at wsor.net
Sun May 23 00:57:10 EDT 2004
> -----Original Message-----
> From: mythtv-users-bounces at mythtv.org [mailto:mythtv-users-
> bounces at mythtv.org] On Behalf Of Steven White
> Sent: Saturday, May 22, 2004 4:58 PM
> To: mythtv-users at mythtv.org
> Subject: [mythtv-users] Script after recording
>
> My MythTV setup is wired through an A/V receiver with the S-Video going
> into my PVR-350. I like being able to route various video sources to
> the box with the receiver. The only problem with my setup is that the
> A/V receiver needs to be on for the S-Video signal to be present at the
> MythTV box. I have modified the changechannel script for my DSS
> receiver to turn on my receiver and mute the speaker audio via RS232
> from the second com port on the mythtv box (the 1st one is attached to
> the DSS receiver). What I'd really like is to be able to fire off a
> script after a scheduled recording is finished. This would allow me to
> send the "off" command to my receiver so that it doesn't have to on all
> the time. Is there an easy way to do this?
>
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
Transcode can be set to run after the capture in the recording profiles
section so maybe if you normally transcode, changing the trancode command to
"[receiver off script] && transcode" or if you don't normally transcode,
just replace it with your script. Worth a try.
-- Travis
More information about the mythtv-users
mailing list