[mythtv-users] Hauppauge PVR-250 difficulties
mythtv at heisterberg.dk
mythtv at heisterberg.dk
Sat Nov 20 19:53:02 UTC 2004
I can only speak as to point 1.
The prebuffering pauses are probably not due to the capture card but
rather to the audio device, or so mine were on a Pundit-R which also has
an asus mobo and uses the atiixp audio driver. The solution was to compile
mythtv from CVS and toggle the audio support from OSS to ALSA. I have had
to set the latency_delay for the pci cards as well.
See the following link:
http://www.gossamer-threads.com/lists/mythtv/users/94706
/lekkim
"Dan" <ddriscall at stny.rr.com>
Sent by: mythtv-users-bounces at mythtv.org
20-11-2004 20:22
Please respond to
Discussion about mythtv <mythtv-users at mythtv.org>
To
<mythtv-users at mythtv.org>
cc
Subject
[mythtv-users] Hauppauge PVR-250 difficulties
I am a Newbie to Linux. I am currently running the default install of
Mandrake 9.1. I installed mythtv from the HOWTO as well as the PVR-250 as
detailed in the "example configurations". My setup uses a celeron P4
1.8GHz, 384Mb PC2100 RAM, and ASUS P4VP-MX motherboard (I am using all the
onboard VIA devices: video, sound, ethernet). The Hauppauge card I am
using
is a PVR-250 model 980 NTSC/NTSC-J. I am experiencing two difficulties
with
watching TV.
1) The first time I start mythfrontend after a reboot everything works ok.
However, if I stop watching tv and then attempt to watch tv again the
signal
becomes choppy and eventually locks up. If I switch over to the terminal
window in which I started mythfrontend I see the message "prebuffering
pause" then "waited 2 seconds for data to become available, waiting
again..". The only way to regain use of the tuner is to reboot the
computer. I tried stopping the ivtv module (and all its dependencies) and
restarting it again without rebooting the computer, but that had no
effect.
I also updated the firmware to the recommended version from the ivtv site
(from file pvr_1.18.21.22168_inf.zip), this had no effect.
2) When I watch TV all I receive is static. I tried fine tuning the
frequency with no success. How are the frequencies set? I use DataDirect
to set the channel info, but maybe I missed a step that sets the channel
frequencies.
I would appreciate any help on these topics
Thanks,
Dan
_______________________________________________
mythtv-users mailing list
mythtv-users at mythtv.org
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mythtv.org/pipermail/mythtv-users/attachments/20041120/d3f16bbb/attachment-0001.htm
More information about the mythtv-users
mailing list