[mythtv-users] Have Lirc & IR Blaster,
now All I need is help making a lirc.conf...
Mike
mythtvuser at optonline.net
Sun Jan 30 10:26:27 EST 2005
I can't say with 100% accuracy your setup is just missing the correct
config as I have seen people have other issues (mainly related to trying
the latest kernel out of cvs along with the latest lirc version out of
cvs and getting warnings about timing parameters which they then ignored)
But, most likely your problem is your config file or your possitioning
of the device in respect to your box. Do you have the device extremely
close to the IR receiver of your cable box? (See picture on
www.irblaster.info )
The only way for you to record a config is to build or buy an ir
receiver that works with lirc. You shouldn't have to do this though
because you are not the only person on this list and the lirc list using
an SA3200.
STEPHEN WANAMAKER wrote:
>As recommended, I tried executing the
>channel change script while holding the other end of
>the IR blaster to a camera to ensure that the blaster
>was attempting to flash the signals. This was
>sucessful and I was able to see it attempt to flash
>the signals. So at this point I am assuming that the
>lirc setup is 100% working, and I am just missing the
>correct lirc.conf for my settop box. Would you say
>that is accurate? If no config exists for the SA
>3200, is there no way to generate one?
>
>
>
>
More information about the mythtv-users
mailing list