[mythtv-users] (OT) TV-Out on a GF4
tehpopa at gmail.com
Mon Jul 11 23:02:01 EDT 2005
Tried that and got nowhere. Tried updating driver to 7664 and got
nothing(was at 7174)
On 7/7/05, Fedor Pikus <fpikus at gmail.com> wrote:
> On 7/7/05, Justin Popa <tehpopa at gmail.com> wrote:
> > Had a thread before about this, but I have hit a new problem now. I
> > use FC3, with a GF4MX440. If I use the default config(xorg.conf.orig)
> > that FC sets up for me(with driver nv changed to nvidia) X loads fine.
> > If I then load my modified conf file over it(xorg.conf.new) and do an
> > init 3/init 5.. everything works perfectly. Then, the next time I
> > boot(using the new conf), I get zero on any display. I've attached the
> > confs, and the X log. Thanks!
> Log is not complete, so it's hard to see what went wrong. After your last line
> (++) using VT number 7
> normally you should see PCI scan lines. If you really don't have them,
> then the driver is hung pretty badly.
> If it works with your original config (with "nvidia" driver), try to
> isolate the problem: first, remove all twinview options. If it works,
> try only these:
> Option "TwinView"
> Option "SecondMonitorHorizSync" "30-50"
> Option "SecondMonitorVertRefresh" "60"
> Option "MetaModes" "800x600, 800x600; 640x480, 640x480"
> Option "TwinViewOrientation" "Clone"
> (Note that your MetaModes line does not match your Modes line later in
> the file, it does not
> list all modes, I don't know if it matters).
> Fedor G Pikus (fpikus at gmail.com)
> mythtv-users mailing list
> mythtv-users at mythtv.org
More information about the mythtv-users