[mythtv-users] 0.18.1 on x86_64 and lirc not working
Jonathan Henry
jon.henry at charter.net
Sun Jun 5 02:57:55 UTC 2005
Okay so I just saw the bug where the updated .18.1 breaks lirc for
x86_64. What should I do to "downgrade" since yum is my primary
software getter? I don't want to have to start over. Should I build
myth from source with the modified configure script?
http://www.mythtv.org/bugs/show_bug.cgi?id=289
On Jun 4, 2005, at 9:21 PM, Jonathan Henry wrote:
> I am having a similar problem - only everything was working fine
> before I upgraded from .18 to .18.1. x86_64 FC3 using Jarod's
> guide and using Yum. I didn't have any problems or errors upgrading
> myth or any of the other packages.
>
> Lircd is running fine and I can see remote commands coming through
> irw, but mythfrontend is not responding to any remote commands. I
> can still use my power button to kill mythfrontend and restart it
> (from jarod's script).
>
> Wife Annoyance Factor is going up by the minute - any help is much
> appreciated.
>
>
> On May 22, 2005, at 1:15 PM, Johan Reinalda wrote:
>
>
>> All,
>> I have just built a new box, based on FC3-x86_64, installed as
>> plain x86_64 without the 32-bit comp. libraries. (on Athlon64 2800
>> +, ECS 755-A2 mobo, 512mb, 200gb, pvr-150mce, nvidia fx5200-svid)
>>
>> Installed lirc 0.7.1 as usual, then installed 0.18.1-x86_64 from
>> the at repo (manually downloading rpms, as yum had some
>> dependency problems with myth-plugins).
>>
>> myth runs fine, with one exception: I cannot get lirc support to
>> work.
>>
>> Using a home brew serial port receiver, the lirc setup shows
>> working when testing with 'mode2' (i see pulses), and with
>> 'irw' (I see the correct buttom definitions, both as root or as
>> mythtv user). However, Myth does not recognize/use lirc...
>>
>> I have the same setup on a development box, running an
>> older&slower original athlon 32bit cpu, and also 0.18.1 (upgraded
>> from the original 0.17 install) There things work. I pulled in the
>> following two lirc config files from this dev system which work
>> there:
>> /etc/lircd.conf
>> ~mythtv/.myth/lirrc
>>
>> One difference I notice is the lack of following type entries in /
>> var/log/message (this does show up for irw, not when starting
>> mythfrontend) :
>>
>> May 22 10:41:06 mythtv lircd-0.7.1[3584]: accepted new client on /
>> dev/lircd
>>
>> What am I missing, or is it just that the x86_64 build does not
>> support lirc?
>>
>> TIA,
>>
>> Johan
>>
>>
>> _______________________________________________
>> mythtv-users mailing list
>> mythtv-users at mythtv.org
>> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>>
>>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
More information about the mythtv-users
mailing list