[mythtv-users] DVB, Diseqc and scan
Simon Kenyon
simon at koala.ie
Mon Jun 13 13:07:43 UTC 2005
On Sunday 12 June 2005 12:29, Johan Tufberg wrote:
> No probs simon ;-).. What linux os are you running? Have you tried the
> linuxtv package and compiled the drivers from their source?!
gentoo
i have tried the dvb driver in the kernel source and the cvs from linuxtv
>
> Anyway, there have to be someone out there who have successfully
> installed and setup diseqc switching (1.0, 2-way). I've read somewhere
> on these lists that the problems with Diseqc was encountered with the
> 0.17 release or I may be wrong in this case?!
>
> I've checked the ouput from mythtv-setup and when I'm using the first
> LNB to scan the transponders I see this command is sent:
>
> "DiSEqC 1.0 Switch - Port 0
> DiSEqC Sending 1.0 Command: e0 10 38 f1"
>
> Shortly thereafter I get a lock on the signal. But when i use the second
> videosource, the one that is connected to LNB2, i get the following
> command:
>
> "DiSEqC 1.0 Switch - Port 1
> DiSEqC Sending 1.0 Command: e0 10 38 f4"
>
> and after this I get No Lock. So from this I see that the commands sent
> to the switch may is only different by the last piece "f1" and "f4". Is
> this correct?! I only have two LNB's.
i have problems before i get to mythtv
i cannot get scan to find channels on the second lnb
well it does find channels but they are from the first lnb (like it didn;
actually switch)
--
Simon
More information about the mythtv-users
mailing list