[mythtv-users] PVR 350 and MythVideo
John Harvey
john.p.harvey at btinternet.com
Fri Jun 17 14:53:57 UTC 2005
Try using the latest ivtv. There were some fixes in
the yuv stuff after 3.6k
John
--- Duncan Brown <mythtv at duncb.co.uk> wrote:
> Hey
>
> So its Friday, and I'm back to the point I left you
> last. Just installed
> the latest ivtv and utils by doing a make && make
> install. Ivtvdev has
> also been installed.
>
> Using xv results in a messed up green/black/purple
> picture. Also I now
> cannot change channel in live tv. The box goes
> through the motions, and
> even displays the right channel info, but it doesn't
> actually change
> channel.
>
> Here is the useful bit from messages
>
> Jun 17 14:08:57 Gobbla kernel: ivtv:
> ==================== START INIT
> IVTV ====================
> Jun 17 14:08:57 Gobbla kernel: ivtv: version 0.3.6
> (k) loading
> Jun 17 14:08:57 Gobbla kernel: ivtv: Linux version:
> 2.6.11-1.27_FC3 686
> REGPARM 4KSTACKS gcc-3.4
> Jun 17 14:08:57 Gobbla kernel: ivtv: In case of
> problems please include
> the debug info
> Jun 17 14:08:57 Gobbla kernel: ivtv: between the
> START INIT IVTV and END
> INIT IVTV lines when
> Jun 17 14:08:57 Gobbla kernel: ivtv: mailing the
> ivtv-devel mailinglist.
> Jun 17 14:08:57 Gobbla kernel: ivtv: Autodetected
> WinTV PVR 350 card
> Jun 17 14:08:57 Gobbla kernel: ivtv: Found an iTVC15
> based chip
> Jun 17 14:08:57 Gobbla kernel: ACPI: PCI Interrupt
> Link [LNKB] enabled
> at IRQ 10
> Jun 17 14:08:57 Gobbla kernel: PCI: setting IRQ 10
> as level-triggered
> Jun 17 14:08:57 Gobbla kernel: ACPI: PCI interrupt
> 0000:00:09.0[A] ->
> GSI 10 (level, low) -> IRQ 10
> Jun 17 14:08:57 Gobbla kernel: ivtv: Unreasonably
> low latency timer,
> setting to 64 (was 32)
> Jun 17 14:08:57 Gobbla kernel: ivtv: VIA PCI device:
> 0x3099 vendor: 0x1106
> Jun 17 14:08:57 Gobbla kernel: ivtv: Failed to load
> module tveeprom
> Jun 17 14:08:57 Gobbla kernel: ivtv: i2c client
> addr: 0x50 not found for
> command 0!
> Jun 17 14:08:57 Gobbla kernel: ivtv: Error -19
> reading Hauppauge eeprom.
> Jun 17 14:08:57 Gobbla kernel: ivtv: Possible
> causes: the tveeprom
> module was not loaded, or
> Jun 17 14:08:57 Gobbla kernel: ivtv: the eeprom
> kernel module was loaded
> before the tveeprom module.
> Jun 17 14:08:57 Gobbla kernel: tuner: Ignoring
> new-style parameters in
> presence of obsolete ones
> Jun 17 14:08:57 Gobbla kernel: tuner: chip found at
> addr 0xc2 i2c-bus
> ivtv i2c driver #0
> Jun 17 14:08:57 Gobbla kernel: ivtv: i2c attach
> [client=(tuner unset),ok]
> Jun 17 14:08:57 Gobbla kernel: saa7115: starting
> probe for adapter ivtv
> i2c driver #0 (0x10005)
> Jun 17 14:08:57 Gobbla kernel: saa7115: detecting
> saa7115 client on
> address 0x42
> Jun 17 14:08:57 Gobbla kernel: saa7115: writing init
> values
> Jun 17 14:08:57 Gobbla kernel: ivtv: i2c attach
> [client=saa7115[50],ok]
> Jun 17 14:08:57 Gobbla kernel: saa7115: status: (1E)
> 0x00, (1F) 0xc0
> Jun 17 14:08:57 Gobbla kernel: saa7127: Ignoring
> new-style parameters in
> presence of obsolete ones
> Jun 17 14:08:57 Gobbla kernel: saa7127: video
> encoder driver version V
> 0.3 loaded
> Jun 17 14:08:57 Gobbla kernel: saa7127: detecting
> saa7127 client on
> address 0x88
> Jun 17 14:08:57 Gobbla kernel: saa7127: Selecting
> NTSC video Standard
> Jun 17 14:08:57 Gobbla rpcidmapd: rpc.idmapd startup
> succeeded
> Jun 17 14:08:57 Gobbla kernel: saa7127: Selecting
> S-Video+Composite
> Jun 17 14:08:57 Gobbla kernel: saa7127: Turn WSS off
> Jun 17 14:08:57 Gobbla kernel: saa7127: Widescreen
> Mode 4:3 Full Format
> Jun 17 14:08:57 Gobbla kernel: saa7127: Selecting
> Normal Encoder Input
> Jun 17 14:08:57 Gobbla kernel: saa7127: Enable Video
> Output
> Jun 17 14:08:57 Gobbla kernel: ivtv: i2c attach
> [client=saa7127[50],ok]
> Jun 17 14:08:57 Gobbla kernel: ivtv: Failed to load
> module msp3400
> Jun 17 14:08:57 Gobbla kernel: tda9885/6/7: chip
> found @ 0x86
> Jun 17 14:08:57 Gobbla kernel: ivtv: i2c attach
> [client=tda9887,ok]
> Jun 17 14:08:57 Gobbla kernel: ivtv: Encoder
> revision: 0x02040024
> Jun 17 14:08:57 Gobbla kernel: ivtv: Encoder
> Firmware may be buggy, use
> version 0x02040011
> Jun 17 14:08:57 Gobbla kernel: ivtv: Decoder
> revision: 0x02020023
> Jun 17 14:08:57 Gobbla kernel: ivtv: Configuring
> WinTV PVR 350 card with
> 10 streams
> Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2
> device, streamtype
> 0 minor 0
> Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA
> stream 0 using 128 16384
> byte buffers 0 kbytes total
> Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2
> device, streamtype
> 1 minor 32
> Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA
> stream 1 using 161 12960
> byte buffers 0 kbytes total
> Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2
> device, streamtype
> 2 minor 224
> Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA
> stream 2 using 165 12635
> byte buffers 0 kbytes total
> Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2
> device, streamtype
> 3 minor 24
> Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA
> stream 3 using 455 4608
> byte buffers 0 kbytes total
> Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2
> device, streamtype
> 4 minor 64
> Jun 17 14:08:57 Gobbla kernel: ivtv: Create stream 4
> Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2
> device, streamtype
> 5 minor 16
> Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA
> stream 5 using 16 65536
> byte buffers 0 kbytes total
> Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2
> device, streamtype
> 6 minor 228
> Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA
> stream 6 using 1024 2048
> byte buffers 0 kbytes total
> Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2
> device, streamtype
> 7 minor 232
> Jun 17 14:08:57 Gobbla kernel: ivtv: Create stream 7
> Jun 17 14:08:57 Gobbla kernel: ivtv: Registered v4l2
> device, streamtype
> 8 minor 48
> Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA
> stream 8 using 20 51840
> byte buffers 0 kbytes total
> Jun 17 14:08:57 Gobbla kernel: ivtv: Create DMA
> stream 9 using 32 65536
> byte buffers 0 kbytes total
> Jun 17 14:08:57 Gobbla kernel: saa7115: decoder set
> norm PAL
> Jun 17 14:08:57 Gobbla kernel: saa7115: set audio:
> 0x01
> Jun 17 14:08:57 Gobbla kernel: saa7115: decoder set
> input (4)
> Jun 17 14:08:57 Gobbla kernel: saa7115: now setting
> Composite input
> Jun 17 14:08:57 Gobbla kernel: ivtv: Setting audio
> matrix to input 3,
> output 1
> Jun 17 14:08:57 Gobbla kernel: ivtv: i2c client
> addr: 0x40 not found for
> command 1074294033!
> Jun 17 14:08:57 Gobbla kernel: ivtv: i2c client
> addr: 0x40 not found for
> command 2150135312!
> Jun 17 14:08:57 Gobbla kernel: ivtv: i2c client
> addr: 0x40 not found for
> command 1076393489!
> Jun 17 14:08:57 Gobbla kernel: ivtv: Switching
> standard to PAL.
> Jun 17 14:08:57 Gobbla kernel: ivtv: i2c client
> addr: 0x40 not found for
>
=== message truncated ===
More information about the mythtv-users
mailing list