[mythtv-users] Pundit-R / PVR-150/250 - it doesn't fit...

Mark Knecht markknecht at gmail.com
Tue Jun 28 17:44:24 UTC 2005


The Pundit-R already has the riser card so the PVRs are parallel to
the motherboard.

The 150 low profile looks like a very reasonable solution. Not, I
think, as well tested as the other PVR cards but worth a shot.

Thanks.

On 6/28/05, Egeekial <egeekial at comcast.net> wrote:
> Well, one solution is the low profile PVR-150. Another would be to get a
> PCI riser card that puts the card parallel to the motherboard.
> 
> Mark Knecht wrote:
> 
> >Hi,
> >   I'm wondering if I've just hit a bit of bad luck here. I have, up
> >until now, been using the Pundit-R as a frontend only machine. I just
> >built up a new one with the intention of making it a backend machine
> >and purchased a PVR-150 as the tuner to go into it. Amazingly, it
> >doesn't fit. The PVR-150 itself is too tall and runs into the chassis
> >of the Pundit-R
> >
> >   Visually it looks like the PVR-250 has the same problem.
> >
> >   Has anyone else had this problem? Was there any solution? If not,
> >then what well-supported replacement for the PVR-150/250 fits the
> >Pundit-R?
> >
> >Thanks,
> >Mark
> >_______________________________________________
> >mythtv-users mailing list
> >mythtv-users at mythtv.org
> >http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
> >
> >
> >
> >
> 
> 
>


More information about the mythtv-users mailing list