[mythtv-users] Video Card Suggestions for DVI/HDMI Output
Michael T. Dean
mtdean at thirdcontact.com
Wed Jun 29 05:03:08 UTC 2005
Chad wrote:
>On 6/28/05, Jon Kunze <jon99ut at gmail.com> wrote:
>
>
>>I recently purchased a Toshiba 52" DLP television, and I'm now
>>interested in upgrading the quality of the MythTV Display. I'm
>>currently using the Svideo out on my Chaintech mother board with the
>>nividia mx440 on board. I would like to use either the HDMI or
>>component input on my new television.
>>
>>What would be the suggestion for doing this output. Would it be
>>beneficial to use the HDMI input as opposed to the Component input?
>>
>>If I use the HDMI input, what would be a good video card to purchase
>>that is compatible with the HDMI input (I'm assuming that I would want
>>to get a video card with DVI output and use a converter to HDMI).
>>
>>Any suggestions would be greatly appreciated, as I'm soon going to be
>>recording and displaying HD recordings, as well as want the upscaling
>>of the DVD video. Thank you.
>>
>There was a thread a while back with a link to an article on DVI vs
>HDMI vs Component. The jist, it really doesn't matter. Whatever is
>cheapest and most available,
>
--as long as it has good impedance characteristics--
> that's the one to choose.
>
>
Article is at http://forum.ecoustics.com/bbs/messages/34579/122868.html
. It basically says you won't know which is better until you try both
on /your/ equipment (and you may have different results with different
components).
>I also read a bit on HDMI, and it sounds like that is the least likely
>choice you want to make. It's nice to have 1 small/single cable to
>run dvi quality with audio, but there were some pitfalls that I can't
>remember right now.
>
>
HDMI = DVI + HDCP (High-bandwidth Digital Content Protection (often
called High Definition Content Protection) = Digital Rights Management =
if the broadcast flag goes through, something Linux will never be able
to support).
Also, HDMI cable is typically thinner than DVI. This means that HDMI
cable is more likely to cause bit errors than DVI (i.e. a particular
HDMI cable might not work with your setup, but DVI cables are far more
likely to work properly, so with DVI, you're less likely to have to do
returns/exchanges).
And, the signal transmission format used by DVI and HDMI (TMDS =
Transmission Minimized Differential Signaling) is based around SDI
(Serial Digital Interface), which was designed for coaxial cables.
However, the designers of DVI/HDMI decided not to use coaxial cables and
instead use balanced, twisted-pair cables--which are significantly less
capable of controlling impedance. This can cause bit errors, and--since
DVI/HDMI do not provide for error correction--display problems.
Component uses and was designed for coaxial cable. In some cases,
component may problems with the black level. If your TV allows for
correction of black level, this won't be a problem, but if not, you may
be stuck with the same "NTSC purple-black" that we've had for 50 years. ;)
Regardless, either approach you take will be so much better than S-Video
that you'll love the results (even if there is a minor improvement in
quality possible using the other solution). Basically, think of it as
upgrading from a Pentium II @ 400MHz to a Pentium 4 @ 2GHz versus a
Pentium 4 @ 2.13GHz. The change will be so dramatic that you will be
happy with the results, and you're unlikely to notice the difference
between the two P4's unless you really look for the difference.
HTH.
Mike
More information about the mythtv-users
mailing list