[mythtv-users] Re: Need Help with FC3 pcHDTV HD-3000 Install
sac238 at yahoo.com
Tue Mar 29 22:29:03 UTC 2005
This is the end of my output for the dmesg. It looks like it loads ok ... or maybe I'm missing something.
...... Linux video capture interface: v1.00
cx2388x v4l2 driver version 0.0.4 loaded
ACPI: PCI interrupt 0000:01:09.0[A] -> GSI 17 (level, low) -> IRQ 217
cx88: subsystem: 7063:3000, board: pcHDTV HD3000 HDTV [card=22,autodetected]
tuner 1-0061: chip found @ 0xc2 (cx88)
tuner 1-0061: type set to 52 (Thomson DDT 7610 (ATSC/NTSC))
cx88/0: found at 0000:01:09.0, rev: 5, irq: 217, latency: 64, mmio: 0xd0000000
cx88/0: registered device video0 [v4l2]
cx88/0: registered device vbi0
cx88/0: registered device radio0
Kenneth Hong <kenneth_hong at hotmail.com> wrote:
The best post I've found so far is here:
It has specific instructions for setting up modprobe.conf, and for making
sure that the drivers are loaded in order. The initial load commands go
into /etc/ rc.d/rc.local. This got me past the Fatal Error messages when I
run # modprobe cx8800. /dev/video32 is now available and mythtvsetup
Beyond that I haven't been able to tune any channels over my HD-3000, and my
PVR-250 seems to be stuck on one channel with the right third of the image
If you have any luck, let me know.
Also, try looking through 3gemail at gmail.com 's postings on the archive site.
Gregg's been trying to work through the HD-3000 install for most of the
month. So, you can see what's worked and what hasn't for him and other
people by following his threads.
> From: "Kelly" navykel at gmail.com
> Sent: Tuesday, March 29, 2005 8:41 AM
> Subject: RE:Need Help with FC3 pcHDTV HD-3000 Install
> Did you get a reply?
> I'm have similar problems with the cx88-dvb not loading up. Had almost
> the same mesg.
mythtv-users mailing list
mythtv-users at mythtv.org
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the mythtv-users