[mythtv-users] Plextor PX-TV402U not recognized by KnoppMythTv
Byron Poland
wpoland at gmail.com
Mon May 2 04:11:44 UTC 2005
On 5/1/05, Nathan Lutchansky <lutchann-mythtvusers at litech.org> wrote:
> On Sun, May 01, 2005 at 04:26:24PM +0100, Peter Pauwels wrote:
> > kernel: usb 3-1: new high speed USB device using ehci_hcd and address 5
> > usb.agent[4333]: wis-ezusb: loaded successfully
> > /etc/hotplug/usb/wis-ezusb: load
> > /usr/lib/hotplug/firmware/ezusb/hpi_PX-TV402U.hex for 93b/a004/1
> > to /proc/bus/usb/003/005
> > kernel: usb 3-1: USB disconnect, address 5
> > kernel: usb 3-1: new high speed USB device using ehci_hcd and address 6
> [reformatted for clarity]
>
> This is how the device gets initialized; when first connected, a new
> firmware is pushed into the USB controller, which then disconnects from
> the bus and reconnects with a new USB ID. So at least the hotplug scripts
> are installed correctly.
>
> Following this you should see a message like "go7007: registering new
> Plextor PX-TV402U-NA" or something. Since you're not, it looks like the
> modules are installed incorrectly. Try running "modprobe go7007-usb" to
> load the modules manually. -Nathan
>
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
>
>
>
On my Ubuntu system, the go7007 firmware (the second firmware loaded)
doesn't load before the go7007-usb module, the fix for that was to
modprobe -r go7007-usb after the firmware got loaded, and then
modprobe go7007-usb to load the module again, and everything works.
More information about the mythtv-users
mailing list