[mythtv-users] Re: DVB setup question
Johan Reinalda
johan at global.thunderbird.edu
Sat Sep 24 22:20:07 UTC 2005
Nick wrote:
>Since 0.17 these tables are not used any more. The only DVB-related
>table is the dtv_multiplex table, which interfaces with the channels
>table to tune to channels. I would check the dtv_multiplex table to
>make sure that the FEC values agree with your channels.conf file.
I checked this table, and it seems to contain the values that I entered as a
transport prior to doing the channel scan. They are correct, although there
are a lot more variables then you can enter; what I entered is correct
(frequency, fec, symbol rate, polarization, etc).
Any other ideas ?
or should I consider getting a different card ? (I have a twinhan, and am
not opposed to getting a nova-clone from Technotrend, and eBay my twinhan)
Thanks,
Johan
-----------
On 23/09/05, Johan Reinalda <johan at global.thunderbird.edu> wrote:
> All,
> I have just added a DVB-S card to my myth system, to replace an external
> satellite receiver pointing to IntelSat-Americas 5.
>
> OS drivers load fine, scan discovered the channels, szap tuning works
> fine,
> and I can view the FTA (free-to-air) channel with mplayer looking at the
> TS
> stream on /dev/dvb/adapter0/dvr0
>
> Running mythtvsetup, and configuring it for the DVB card, then in the
> Channel Edit section, I setup a transport for the transponder I want, and
> do
> a channel scan: this find all the fta channels just fine, and seems to
> populate them into the database.
>
> When I next run myth, I see the new fta channels in the guide, but I
> cannot
> switch to them in Live TV, or setup recordings.
>
> In the backend log, I see the following error:
> DVB#0 WARNING - Unsupported fec_inner parameter.
> followed by messages that seem to indicate a transponder lock (ie proper
> tuning):
> DVB#0 Status: LOCK.
> DVB#0 Multiplex Locked
> DVB#0 Successfully tuned to channel 153.
>
> Also, the database tables that seem to relate to dvb
> (dvb_channel,dvb_pids,dvb_sat,dvb_signal_quality) are all emtpy!
>
> What am I missing here? How do I get the tables properly populated? (ie
> why
> does the channel scan not fill these?)
Since 0.17 these tables are not used any more. The only DVB-related
table is the dtv_multiplex table, which interfaces with the channels
table to tune to channels. I would check the dtv_multiplex table to
make sure that the FEC values agree with your channels.conf file.
> Or does the atrpms version not support DVB ? (I'm running 0.18.1-114,
> x86_64) Ie. should I recompile?
This should have DVB support already (at least the X86_32 version do).
Nick
More information about the mythtv-users
mailing list