[mythtv-users] First Generation Air2PC Card Requires Extended Initialization

Mark J. Small msmall at eastlink.ca
Sat Jan 28 17:11:16 UTC 2006


On January 28, 2006 12:52 pm, Steve Malenfant wrote:
> For the Air2PC card, it seems like it's normal...   Even if it shows
> that it can't get alock for a few minutes, it is getting it anyway.
> Your backend will start normally and start recording just fine after a
> few minutes.  I don't really like that, but that's the way it is.
>
> I got 3 cards, and there might be one of them that gives a good status
> when I boot up my machine.  I don't know if it has to do with 2 cards
> being in the system instead of just one.
>
> Steve

Any word on whether these puppies support QAM256, or if they ever will?

Mark


>
> On 1/28/06, William Powers <wepprop at sbcglobal.net> wrote:
> > I recently purchased first generation Air2PC cards off eBay.  I knew
> > there might be issues, but it seemed like a low-cost way to experiment
> > with digital / HD TV and that has proven to be true.  In fact, the first
> > card worked extremely well, no issues whatsoever, so I bought a second
> > one.  The second card, however, takes much longer to initialize and lock
> > up on its startup channel - usually several minutes as compared to less
> > than 30 seconds for the first card I bought.  Once initialized, both
> > cards work fine.  However, mythbackend gives up after 30 seconds so
> > getting them both initialized is a problem.
> >
> > I found I could fix that problem by editing 'dvbchannel.h' in libmythtv,
> > the line that reads:
> >
> > "bool TuneTransport(dvb_channel_t& channel, bool all=false, int
> > timeout=300000);"
> >
> > Adding an extra zero to the 'timeout' parameter allows the backend to
> > wait long enough for my slow card to achieve a lock.  However, I'm
> > curious if there is an easier way.  For example, is there some way to
> > condition the card(s) prior to starting the backend that would allow
> > them to successfully lock up within the default 30 seconds?
> >
> > Also, change of subject, is there some trick to getting XvMC to actually
> > work?  When I first tried to use it on two machines, both with 0.18.1,
> > FX5200's and the NVIDIA driver, only the Hardware MPEG checkbox was
> > present on the Playback settings page.  On both machines, when that
> > checkbox was checked, playback and live TV would both fail with a
> > message saying that the frontend was unable to initialize the display.
> > After fooling around with the stuff mentioned above, including a
> > recompile of 0.18.1, a checkbox to enable OpenGL vsync suddently
> > appeared on the same settings page as the XvMC checkbox and now XvMC
> > works on that machine.  But I don't know why it started working and I
> > haven't been able to duplicate the feat on my other Myth box.
> >
> > Bill
> > _______________________________________________
> > mythtv-users mailing list
> > mythtv-users at mythtv.org
> > http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users


More information about the mythtv-users mailing list