[mythtv-users] New 45-button hauppauge remote problem
Harry Orenstein
holists at verizon.net
Fri Mar 17 02:12:30 UTC 2006
On Thursday 16 March 2006 4:53 pm, Nick wrote:
> On 16/03/06, raptorjr <raptorjr at hotmail.com> wrote:
> > I wonder if anyone has a working setup with the new hauppauge 45-button
> > remote?
<snip>
> You can find the current lircd.conf here
> (http://cvs.sourceforge.net/viewcvs.py/lirc/lirc/remotes/hauppauge/lircd.co
>nf.hauppauge?view=markup)
>
> The remote (as with all Hauppauge remotes) uses the RC5 protocol. I
> would make sure you have the correct lircd.conf installed, then run
> 'irw' with the remote and see if the keys are consistently and
> correctly identified. If you still see problems, such as keys not
> being detected, or different output when pressing the same button,
> check the batteries in the remote.
>
> Nick
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
... or download the full RC-5 config file from the LIRC site
(http://lirc.sourceforge.net/remotes/rc-5/RC-5) and install it. As long as
your remote is sending valid RC-5 codes they should be recognized using this
config. Press all the buttons and copy only the codes that the remote sends
to a new config file. Then rename the key names to something you will
recognize (1, 2, up, down, etc.).
HTH!
-- Harry O.
More information about the mythtv-users
mailing list