[mythtv-users] Streamzap Remote Configuration, almost there!

[John Pierce]

Hello, I have mythtv running on top of a pvr500 and have installed my
new streamzap usb receiver.  I had to rebuild lirc from tarball as
atrpms did not have a usb enabled remote.  If I run lircd -n from the
command line and I run irw in another window I see that lircd accepted
a new client but irw gives no response from button presses.  Mode2
will yield responses to the button presses.  When I launch
mythfrontend I see that lircd accepted a new client, but the remote
does not control the program.  I have an lircrc in ~/.mythtv/ and it
has been designed for the streamzap remote.

I know that I am close, but just cannot figure out where to go next on
the configuration trail.

Any thoughts would be appreciated.

John
--
Registered Linux User 263680, get counted at
http://counter.li.org