[mythtv-users] new user - fuzzy video, low audio - WinTV PVR350 no TV-OUT FC4
Steven C. Liu
sliu at steven-c-liu.com
Mon Mar 27 04:06:32 UTC 2006
Thanks, Brian, for gently insisting that I check my cable, etc. Turned
out that replacing the cable did the trick.
As for the volume, I found out how to adjust the default in the myth
front end config gui. However, all is still not well, but I'll start
another email thread for that. For now - thanks!
Steve
Brian Wood wrote:
>
> On Mar 26, 2006, at 2:52 PM, Steven C. Liu wrote:
>
>> Brian Wood wrote:
>>
>> I don't have a TV connected to that specific cable, but I have a
>> fully-functional signal coming out of a common splitter that goes
>> into a XP box with a WinTV PVR-150 card.
>
>
> Well a cable or connector could be bad, or the splitter itself. The
> only way to be absolutely sure is to connect a known good TV set to
> the exact same connector.
>
>>
>> As far as HRC and IRC are concerned, I don't understand. I'm not
>> using a cable box - it is just a straight cable from the outside (it
>> is not a signal issue since all is fine on my XP/PVR-150 box that
>> shares a cable into a splitter).
>>
>
> HRC/IRC have nothing directly to do with a cable box. There are (in
> the USA) three possible standards for frequency allocation -
> STD/HRC/IRC. Without going into detail it just means that the carriers
> run on slightly different frequencies. Often the AFC in a tuner can
> make up for the variances but sometimes not.
>
> But if you have a 150 similarly configured that is probably not your
> problem. You should do the standard PVR thing of powering down for
> several minutes to be sure your card is not storing some oddball setup
> parameter though. You could swap the PVR cards between the machines to
> see if the problem follows the card, PIA but definitive.
>
> Is there a pattern to the channels that you do get with ivtvctl
> ?Perhaps you are only getting the lower frequency channels, or the
> higher ones ? This can get very confusing because the actual order of
> channels is 2-6, 14-22, 7-13, 23-60 etc. If you are getting or not
> getting only channels 5 and 6 you almost certainly have an HRC/IRC
> problem. Only getting the lower or higher frequencies could point to a
> connector or splitter problem.
>
> Reset the 350, and if you still have trouble try to get more info
> about exactly what you can and can't get, maybe we can figure out from
> the pattern what's going on.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mythtv.org/pipermail/mythtv-users/attachments/20060326/05973f3a/attachment.htm
More information about the mythtv-users
mailing list