[mythtv-users] How to migrate a disk in SW RAID? WAS:Re: RAID 5 of different sized disks for mythtv storage?
adeffs.mythtv at gmail.com
Tue Sep 12 17:42:56 UTC 2006
On 9/12/06, list at onnow.net <list at onnow.net> wrote:
> Quoting Steven Adeff <adeffs.mythtv at gmail.com>:
> > On 9/11/06, list at onnow.net <list at onnow.net> wrote:
> >> I have a 4 disk RAID in hda(b)(c)(d)
> >> I am adding a prommise IDE controler.
> >> I want to migrate the raid setup to be hda hdc hdf hdh
> >> Any one know how to do that? The data on the drive will still be
> >> there, I just have to tell it to look somehwere else.
> >> Also, can anyone confirm that a single promise PCI ATA add in card has
> >> two seperate BUS's? I am trying to break my RAID to one drive per BUS.
> > If you set your partitions to be "fd" (linux raid auto-detect) then
> > you should be fine, the drives contain "signatures" of sorts that let
> > the kernel RAID driver know what partitions belong together. I've
> > moved Software RAID arrays between machines and the autodetect always
> > properly put the array together.
> > As for the Promise PATA card... Each channel on the old ATA is what
> > one could consider a seperate bus. (ie they can be used
> > simultanesouly, unlike two drives on the same channel)
> The drives have no partitions on them. They are wholely used in the RAID5.
> Command (m for help): p
> Disk /dev/hdd: 320.0 GB, 320072933376 bytes
> 255 heads, 63 sectors/track, 38913 cylinders
> Units = cylinders of 16065 * 512 = 8225280 bytes
> Device Boot Start End Blocks Id System
> Command (m for help): q
> Is that odd?
I didn't think you could create an array without partitions.
So I'll say its odd. But others may know better than I.
Before you ask, read the FAQ!
then search the Wiki, and this list,
Mailinglist etiquette -
More information about the mythtv-users