[mythtv-users] ac3 passthrough problems
Michael T. Dean
mtdean at thirdcontact.com
Thu Sep 21 21:00:24 UTC 2006
On 09/21/06 15:36, Scott wrote:
> On Sep 21, 2006, at 2:17 AM, Thomas Börkel wrote:
>
> >> With the config shown above, I get a nasty stuttering sound that
> >> might sound like a helicopter whirling it's blades :) If I do not
> >> check the "enable AC3/DTS passthrough" options then I get normal
> >> sounding audio but not DD or DTS format. My receiver says I'm
> >> instead receiving a PCM 48kHz signal from the SPDIF. Using
> >> mplayer on the same test clip shows DD 5.1 with the -afm hwac3
> >> pass through option.
> >
> > Apparently, Myth sends raw AC3 data to Alsa and Alsa does not
> > switch your receiver to DD.
>
> Not necessarily. It's perfectly possible to send analog format
> signals out the spdif and for the receiver to decode them.
It is not the responsibility of the underlying driver to tell the
receiver to switch modes when the application changes audio
formats--it's the application's responsibility. Some receivers are
better at "auto-detecting" formats than others. Some sound cards are
better at creating specification-compliant data streams which enhance
the receiver's ability to auto-detect.
Myth doesn't yet do well at informing the receiver of the audio stream
type (because all previous attempts to add functionality to do so have
broken more systems than they've fixed--and not just because of bad
configurations).
Mike
More information about the mythtv-users
mailing list