[mythtv-users] Homebrew Serial Receiver Problems
Jeremy Gillick
myth at mozmonkey.com
Mon Feb 26 17:00:18 UTC 2007
> Have you checked to see if you have the serial port turned on in your
> bios?
I believe so, but then again I've never messed with serial port stuff
before. When I'm in the bios under Onboard Devices it says:
Serial Port A: 3F8-3FF, IRQ 4
Serial Port B: 2F8-2FF, IRQ 3
I don't see anywhere to enable or disable it.
> Have you tried to test the remote, with typing mode2 in a terminal
> to see if the remote is sending?
>
I have with no success. It doesn't recognize anything. I then tested
the serial port with my multi-meter to find that it is not powering the
receiver.
> If you are using the Huppauge receiver why not use the port on your 150?
> I don't know where you are located,but may be you should buy the parts
> as listed on that site(the Huppauge may need different components to
> work) and get it working and then modify it to suit your setup....
>
I believe the Hauppauge system is proprietary and will only accept their
remote -- I'm trying to use a different remote. What parts are you
talking about?
> Not much help, but a few suggestions....
> Good luck....
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
Thanks,
Jeremy
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mythtv.org/pipermail/mythtv-users/attachments/20070226/82a06e3a/attachment.htm
More information about the mythtv-users
mailing list