[mythtv-users] How do I have it only use the channels I scanned?
Xamindar
junkxamindar at gmail.com
Wed Jan 17 08:12:22 UTC 2007
Tom Lichti wrote:
> Udo van den Heuvel wrote:
>
>> Xamindar wrote:
>>
>>> I have to use mythweb to do this? Oh well, it's a good reason to get
>>> mythweb set up. Thanks for the info. Is there one box to check to tell
>>> mythtv to only show the channels that it scanned and found? Selecting
>>> each channel is going to take some time and I have to keep looking at
>>> mythsetup to see which channels it found.
>>>
>> You can also go into the database afterwards, perhaps using phpmyadmin,
>> and make the channels (in)visible. I guess you need to check the
>> channels table.
>>
>
> Or you could use mythtv-setup, as a supported method. MythWeb would be
> the easiest though, since you can do them en masse, as opposed to one by
> one.
>
> Tom
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
>
Thanks for the replies guys. I'll try your suggestions. I do have one
last question though. Then what is the point of the channel scanner?
More information about the mythtv-users
mailing list