[mythtv-users] Confused on how to use channels.conf
support at ocg.ca
Fri May 25 18:15:31 UTC 2007
Is the format below good?
And....I'm not trying to do a scan afterwards. As soon as I click next (to
import the channels.conf) a scan begins. Any ideas?
From: mythtv-users-bounces at mythtv.org
[mailto:mythtv-users-bounces at mythtv.org] On Behalf Of Nick Morrott
Sent: Tuesday, May 22, 2007 7:49 PM
To: Discussion about mythtv
Subject: Re: [mythtv-users] Confused on how to use channels.conf
On 22/05/07, Michelle Dupuis <support at ocg.ca> wrote:
> I have my DVB-S card driver working, and scandvb finds the satellite
> and lists a bunch of channels!! YAY! (This is a thrill for me, as I
> didn't think I would get this far)
> I used scandvb to create a channels.conf file whose contents looks
> like this (cut off after the first five lines):
> I then went to myth's back-end setup, where I have setup the dvb-s
> card and the video source. I then created a new input and tried to
> scan the satellite. I told myth to use the channels.conf I created,
> but then Myth just times out while scanning (can't get a lock) - and
> signal strength is 0%.
If you import a good channels.conf file, you should not need to then scan
for channels - this is the purpose of importing the (dvb)scan-generated
channels.conf file in the first place.
MythTV Official wiki:
MythTV users list archive:
"An investment in knowledge always pays the best interest." - Benjamin
mythtv-users mailing list
mythtv-users at mythtv.org
More information about the mythtv-users