[mythtv-users] Remote Control on MythTV

Alysson Costa alyssonmc at gmail.com
Mon Nov 12 19:07:05 UTC 2007


I'm using a Leadership GOTEC 3801, made for Windows MCE.
As receptro, I'm using a homebrew serial device.

I made my lircd.conf using a irrecord.

tks

Alysson


On Nov 12, 2007 4:16 PM, Nick Morrott <knowledgejunkie at gmail.com> wrote:
> On 12/11/2007, Alysson Costa <alyssonmc at gmail.com> wrote:
> > Hi,
> >
> > I'tm try to configure a homebrew IR receiver using serial port.
> > When I run irrecord everthing works fine, it recognizer each key
> > pressed and I put the name;
> > but when I use irw it recognizes same code for diferent pressed key.
> >
> > How to configure it?
>
> It could depend on a) which remote control you are 'learning' with
> irrecord, and b) whether you are recording in raw mode, or using a
> remote control header header file for your remote control, if you know
>  which protocol it is using.
>
> As Sean says, you can check the LIRC.org website/CVS browser for an
> existing lircd.conf config file for your remote.
>
> --
> Nick Morrott
>
> MythTV Official wiki:
> http://mythtv.org/wiki/
> MythTV users list archive:
> http://www.gossamer-threads.com/lists/mythtv/users
>
> "An investment in knowledge always pays the best interest." - Benjamin Franklin
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>



-- 
Alysson Magalhães da Costa
e-mail : alyssonmc at gmail.com
MSN : alysson_mc at hotmail.com
Celular : (61) 8143-8800
VoIP : (31) 4062-7563


More information about the mythtv-users mailing list