[mythtv-users] 20.2 Commercial Flagging
Michael T. Dean
mtdean at thirdcontact.com
Wed Sep 5 17:24:41 UTC 2007
On 09/05/2007 08:30 AM, Craig Treleaven wrote:
> Automatic commercial flagging is not working for me. It starts
> immediately after a program begins recording (ATSC only via the
> HDHomeRun) but the log reports zero breaks. An excerpt of the
> MythBackend log is below. If I run CommFlag 'manually' from the
> Watch Recordings screen, it seems to complete successfully and find
> most (or all) the commercial breaks.
> I notice that sometimes CommFlag reports that it is finished even
> before the show is fully recorded. In one case, it 'finished' 7
> seconds into a 60 minute recording.
> Is it because I have marginal reception? I get a lot of log entries
> complaining about mpeg2 issues. Looking at a log for two days
> (believe I recorded 13.5 hours of OTA ATSC) showed over 80,000 such
> log entries.
Most likely the reception issues. Chances are, mythcommflag is crashing
(because of libav*'s inability to handle the corrupted stream), so it
"finishes" early. This happens occasionally for me, too (though only
about once in 100 recordings--I have pretty good signal quality).
More information about the mythtv-users