[mythtv-users] Master Backend video cards show not connected
jnissley at nissley.org
Sun Sep 23 01:04:23 UTC 2007
I just added a PVR-500 to my slave back end yesterday. Since then the
master backend is showing the two PVR-150's that I have in it as remote
and not connected. The PVR-150's worked well until the PVR-500's were
put in. One other thing I noticed is that the PVR-150's have taken on
the name (Master) instead of the host name of the server. Master is the
special name I gave my front end that is on the master back end. I have
had the name of master for my front end on the master back end for a few
months already without any issue.
Master backend info
[root at mythtv
<http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users> ~]# rpm -qa |
Slave backend info
[root at mythtv2
<http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users> etc]# rpm -qa
| grep ivtv
[root at mythtv ~]# /bin/dmesg |grep Initialized
ivtv0: Initialized Hauppauge WinTV PVR-150, card #0
ivtv1: Initialized Hauppauge WinTV PVR-150, card #1
[root at mythtv ~]#
As you can see the cards do show up just fine in the config.
I also checked my messages log file upon reboot of the master server and
the PVR-150 cards load fine without any errors. It just appears that
the master backend does not know they exist because it thinks they are
on a remote backend for some reason.
Any ideas would be appreciated.
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
More information about the mythtv-users