[mythtv-users] 1 of 2 dvb-s cards no longer work - DiSEqCDevTree, Error: FE_SET_TONE failed

covert covert thecovert at gmail.com
Sat Aug 30 05:42:26 UTC 2008


On Sat, Aug 30, 2008 at 3:22 PM, covert covert <thecovert at gmail.com> wrote:
> I have 2 dvb-s cards running in my MythTV. Both are set up the same.
> Recently one card stopped working. Errors from BE log attached. I
> changed the non working card to another card to check it was not a
> faulty card and I still got the same error. I swapped over inputs
> between the 2 cards to eliminate a faulty LNB and still the same
> error.
>
> I have deleted the cards a few times in the setup and re-set it up and
> I still get the same error. I can also still successfully scan
> transponders in the setup page with the card.
>
> TVRec(27): Changing from None to WatchingLiveTV
> TVRec(27): HW Tuner: 27->27
> DiSEqCDevTree, Error: FE_SET_TONE failed
>   eno: Bad address (14)
> DVBSM(3), Error: Can not read DVB status
>   eno: Bad address (14)
> DVBSM(3), Warning: Can not measure Signal Strength
>   eno: Bad address (14)
> DVBSM(3), Warning: Can not measure S/N
>   eno: Bad address (14)
> DVBSM(3), Warning: Can not measure Bit Error Rate
>   eno: Bad address (14)
> DVBSM(3), Warning: Can not count Uncorrected Blocks
>   eno: Bad address (14)
>
> Any suggestions of what else to check ?
>

No sooner than when I had sent this message I solved it. In the
cardinput and capturecard tables the cardid was not matching up. One
was 26 in one table and 27 in the other.


More information about the mythtv-users mailing list