[mythtv-users] Issues with Antec Fusion 430, Hauppauge-WinTV-PVR-150 w/ remote and Mythbuntu 7.10

G L glafranceweb at yahoo.com
Fri Jan 18 10:31:47 UTC 2008


Hello!

Actually I only have /dev/lirc0 in there.

irw doesn't give my anything, but mode2 and irrecord do...

I just looked at the remote itself, it says "RC6" at the back.


Guillaume


----- Original Message ----

From: Henrik Beckman <henrik.list at gmail.com>

To: Discussion about mythtv <mythtv-users at mythtv.org>

Sent: Friday, January 18, 2008 4:25:09 AM

Subject: Re: [mythtv-users] Issues with Antec Fusion 430, Hauppauge-WinTV-PVR-150 w/ remote and Mythbuntu 7.10



I suspect that your problem is that lirc detects multiple remote recivers, the one in your case and the one on the card.

Im working on a similar problem at home sto this is BETA info!



Run the command irw do you get anything when you push the keys ? 

If not do an ls /dev/lirc* I suspect that you get several lirc and lircd there, so for each lircd do

irw /dev/lircd(number)  and try with the remote

No signal, you might need to modify /etc/init.d/lirc and change /dev/lirc0 to /dev/lirc1 and /dev/lirc/0 to /dev/lirc/1 



Then try to run irw again.



Once you get something back from irw on /dev/lircd you should be good to go.



/Henrik

 




On 1/18/08, G L < glafranceweb at yahoo.com> wrote:

> Hello everybody,

>

>

>  I'm trying to setup a Mythbuntu 7.10 computer with the following hardware:

> -Antec Fusion 430

> -Biostar TF7050-M2 motherboard 

> -Hauppauge-WinTV-PVR-150 card (comes with a remote control)

> -Wireless LAN card, 2GB ram, 500GB harddrive

>

>

>  My two main problems right now are:

>

> 1. Getting the remote that came with my PVR-150 to work with the IR receiver built in the VFD screen. 

> 2. Getting the VFD screen to show things


>
> First, about the remote.
> 
> With irrecord, I can make little . dots appear when I press on buttons
 on the remote. With mode2 I can get it to show things like "code:
 0x800f041e" when I press 
> on buttons on the remote. I cannot make irw react
 though, it's like I'm not doing anything. 
> 
>  In Mythbuntu Control Centre -> Remote Control,  I have 'Hauppauge TV
 card' selected.
> 
>  When I load MythTV, it doesn't react at all to keypresses on the
 remote control. 





More information about the mythtv-users mailing list