[mythtv-users] OT: Re: HDMI_SPDIF directly to reciever
James
bjlockie at lockie.ca
Sat Jul 5 22:40:30 UTC 2008
OTAlen Edwards wrote:
>
>
> James Lockie wrote:
>> Alen Edwards wrote:
>>>
>>>
>>> James Lockie wrote:
>>>> Brian Phillips wrote:
>>>>
>>>>> I think I can say why yours is working correctly.
>>>>>
>>>>> Your signal is a purely electrical SPDIF signal. Even though it's
>>>>> not
>>>>> according to the -0.5 to +0.5 spec, it works because SPDIF is pretty
>>>>> versatile. I have driven SPDIF signals successfully with 0V to
>>>>> +5V swings
>>>>> (not recommended, but it produces sound) and I have driven SPDIF
>>>>> signals
>>>>> successfully with 0V to +250mV swings. Again, not recommended but it
>>>>> produces sound.
>>>>>
>>>>> Brian
>>>>>
>>>> Am I risking frying my motherboard or receiver?
>>>>
>>>> _______________________________________________
>>>> mythtv-users mailing list
>>>> mythtv-users at mythtv.org
>>>> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>>>>
>>>>
>>>
>>> You certainly are risking frying the receiver. If that goes, there
>>> is a small chance it could take out the MB.
>>>
>>> Build the network or buy the adapter.
>>>
>>> Allen
>> Yamaha said my receiver expects 5 volts.
>> ASRock never answered (that was a month ago).
>>
>> There is 0 volts on the RCA.
>>
>> Why do I get sound if there is a zero volt signal?
>> I tested my voltmeter on a battery to verify it works.
>>
>>
> You should read 0 volts with a S/PDIF signal. They are 0 volts DC and
> the AC is too high a frequency for my and apparently your voltmeter to
> read. If you had a TTL signal, you would register about 2 volts with
> the VM set to DC. If your RX expects 5 volts and your MB reads 0, I
> would guess it would work and you won't hurt anything (don't sue me, I
> can't pay anyway).
>
>
> Allen
>
> .
>
I bought a new meter and it says 1.4V DC :-(
I put a picture up at: http://lockie.ca/test/voltage.jpg but I doubt it
is very helpful.
So if my RX expects 5V (DC?) and it is getting 1.4V DC and I have sound,
do I need the circuit?
TTL is +5V, and SPDIF is -.5 to +.5V so what is my MB outputting?
More information about the mythtv-users
mailing list