[mythtv-users] How to "Apply" an Edit in editing mode

Michael T. Dean mtdean at thirdcontact.com
Fri Sep 5 20:19:14 UTC 2008


On 09/05/2008 04:12 PM, Bobby Gill wrote:
> I am just a bit confused about this, I have a program where I went 
> into Edit Mode, set two cut points (delete before frame and then 
> delete after frame, leaving desired space in between I want to trim 
> down to), and I hit X as I have seen instructed in another thread. It 
> doesn't show up in Job Queue, is it just going to take some time to 
> cut out the parts and trim the recording down so I should check back 
> later, or how does it work?

Were you back in playback mode when you hit X?  (I.e. leave editing 
mode, then hit X and see what happens.)

Mike


More information about the mythtv-users mailing list