[mythtv-users] How to "Apply" an Edit in editing mode

[Bobby Gill]

On Fri, Sep 5, 2008 at 4:19 PM, Michael T. Dean <mtdean at thirdcontact.com>wrote:

> On 09/05/2008 04:12 PM, Bobby Gill wrote:
> > I am just a bit confused about this, I have a program where I went
> > into Edit Mode, set two cut points (delete before frame and then
> > delete after frame, leaving desired space in between I want to trim
> > down to), and I hit X as I have seen instructed in another thread. It
> > doesn't show up in Job Queue, is it just going to take some time to
> > cut out the parts and trim the recording down so I should check back
> > later, or how does it work?
>
> Were you back in playback mode when you hit X?  (I.e. leave editing
> mode, then hit X and see what happens.)
>
> Mike
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>

I hit X and it sends me back to Watch Recordings from where I had played the
recording. When I go back into the recording in question and hit E for edit
mode, it says it's being edited and I can select continue editing or do not
edit.

Bob
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mythtv.org/pipermail/mythtv-users/attachments/20080905/bf4b23c4/attachment.htm