[mythtv-users] Jamu without storage groups
cforker at gmail.com
Sat Dec 26 19:06:39 UTC 2009
I had this issue as well last week when setting up a new myth box. I ran
jamu and it changed all the mythvideo paths to the storage group ones so
they wouldn't launch with vlc afterwards. The solution was to delete all
the storage groups, including the artwork ones (videos, banners, coverart,
fanart, and screenshots) for mythvideos and metadata. I did this with
mythtv-setup --> Storage Groups and then by just going into each storage
group and deleting the path. Be sure to keep the default storage group for
TV. Then make sure the correct local paths for those groups are defined in
Utilities/Setup --> Setup --> Media Settings --> Video Settings --> General
Settings. Run Jamu again after that and it worked for me.
On Sat, Dec 26, 2009 at 8:21 AM, Andrew Lee <andrewkl at enclavenet.com> wrote:
> Anyone know how to use Jamu.py without storage groups? In order to use it
> for mass updating, I have to temp. set the storage group to where all my
> videos are stored. However the paths of the files after mass updating are
> wrong in the videometadata folder. They correspond to storage group paths. I
> dont want to use storage groups because I am using mplayer. So when I switch
> the SG videos directory to some other directory in order to disable it, all
> the metadata is not pulled for the files using the frontend. If I try to run
> jamu.py with my SG video path set to nothing, of course it will see no video
> files. It seems that the new jamu.py only looks for SG and cannot be used
> without them. I guess my question is this:
> How do I disable storage groups?
> How do I use Jamu.py to update the videometadata table without using
> storage groups?
> mythtv-users mailing list
> mythtv-users at mythtv.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the mythtv-users