[mythtv-users] After upgrading from .21 to .22 my Hauppauge PVR-500 now shows as remote and disconnected, part 2

[Matt Beadon]

> How does mythtv know where the encoders are?

That's stored in the DB AFAIK


> I have been through my setup 4 times, all my IP addresses are correct,
> however the encoders are always reported by mythweb as remote and
> disconnected. Watching TV shows only the encoders that actually are remote.
>
> If I re-run mythtv setup, and specify everything as 127.0.0.1 (on my master
> backend, where the encoders actually are), should that not force mythtv to
> accept the encoders as local?
>
>
I saw something similar when I changed my hostname on my system without
following the instruction here:
http://www.mythtv.org/wiki/Database_Backup_and_Restore#Change_the_hostname_of_a_MythTV_frontend_or_backend

I went back to the old hostname and my tuners returned.  Maybe you did the
same?

Do the tuners still work outside of mythtv?  i.e.  mplayer /dev/video0

good luck,
Matt
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mythtv.org/pipermail/mythtv-users/attachments/20091116/4822f629/attachment.htm>