[mythtv-users] Looking for a New remote
beww at beww.org
Sun Dec 26 17:54:45 UTC 2010
On 12/26/2010 09:00 AM, Raymond Wagner wrote:
>>> In the interest of adding actual value to this thread: I keep a
>>> pencil eraser next to the charging cradle and every so often rub
>>> down the contacts on the remote and the cradle. I also keep a C cell
>>> battery nearby to put weight on the remote so it will maintain
>>> contact once established. That has worked so far although there is
>>> some amount of jiggling involved to get it to make contact in the
>>> first place.
>> Solder is not that great a conductor, the flux contains horrible things,
>> and its application will also destroy the gold-plated connectors (if
>> they were there), and solder is not very corrosion resistant.
> The gold plating had already scratched off of my mouse before I resorted
> to solder. After two years, I'm seeing a lot of corrosion at the edge
> between the solder and the original contact, but the actual point hit by
> the charger is clean and I have no problem getting it to charge.
The interface where you are seeing corrosion has solder, flux, the
original contact material and probably some moisture. It's a veritable
Witches Brew of chemicals that will eat anything over time. The heat
added when the solder bead was applied got things off to a good start.
Other than replacing the contacts, I don't really see any good solution
once you have got to the point you are at. Continuing the way you are is
about the only answer.
The real problem is poor design in the first place, again if I had paid
hundreds of dollars for something so crappy I'd not be a happy camper.
More information about the mythtv-users