[mythtv-users] Continuing the lirc Fedora14 issue with PVR350

The Walters sbwalters0731 at gmail.com
Mon Feb 7 14:30:45 UTC 2011


>>//  This past week had to replace a dead motherboard on a system that has been running solid for 4 years with myth 0.21 and fedora 8.  Did a clean install of Fedora 14 and mythtv 0.24.  All is working well except for PVR350 remote (I have a 150 in the system as well no remote input).  I have seen where ivtv has move to the kernel and lirc_zilog is now going to be the standard.  Don't have an IR Blaster just a receiver.
//
>/lirc_zilog is for devices with a zilog z8 chip on them, which all support both
/>/send and receive. You still use lirc_i2c or ir-kbd-i2c for devices that do
/>/receive only (lirc_i2c is going away, ir-kbd-i2c is the way forward, can still
/>/be used with lirc using its devinput driver).
/
Thanks, didn't realise that.

I set LIRC_DRIVER="devinput" but it still comes up with lirc_zilog.  If I modprobe ir-kbd-i2c then lsmod|grep -i lirc i get
ir_lirc_codec           3417  0
rc_core                14291  9 ir_lirc_codec,ir_sony_decoder,ir_jvc_decoder,ir_rc6_decoder,ir_rc5_decoder,rc_rc5_tv,ir_nec_decoder,ir_kbd_i2c
lirc_zilog             11784  0
lirc_dev               12896  2 ir_lirc_codec,lirc_zilog
i2c_core               21328  18 ir_kbd_i2c,lirc_zilog,msp3400,saa7127,saa7115,tuner_simple,wm8775,tda9887,tda8290,tuner,cx25840,nvidia,ivtv,v4l2_common,videodev,i2c_algo_bit,i2c_nforce2,tveeprom

dmesg
[ 3376.918767] IR NEC protocol handler initialized
[ 3376.932119] IR RC5(x) protocol handler initialized
[ 3376.937260] IR RC6 protocol handler initialized
[ 3376.942858] IR JVC protocol handler initialized
[ 3376.947887] IR Sony protocol handler initialized
[ 3376.952063] Registered IR keymap rc-rc5-tv
[ 3376.952326] input: i2c IR (Hauppauge WinTV PVR-350 as /devices/virtual/rc/rc0/input7
[ 3376.953534] rc0: i2c IR (Hauppauge WinTV PVR-350 as /devices/virtual/rc/rc0
[ 3376.953542] ir-kbd-i2c: i2c IR (Hauppauge WinTV PVR-350 detected at i2c-2/2-0018/ir0 [ivtv i2c driver #1]
[ 3376.955127] IR LIRC bridge handler initialized

I restart lirc and then check irw but still no luck.  I have lircd.conf in /etc/lirc/ and my .lircrc file in the .mythtv folder.
Do i also need to set the LIRC_DEVICE? (I think the virtual device is what I need.  I saw in my searching that this is probably /dev/input/event7?)

(sorry about the other post thought I hit reply)

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mythtv.org/pipermail/mythtv-users/attachments/20110207/a6475549/attachment.htm>


More information about the mythtv-users mailing list