[mythtv-users] I would appreciate some help with Satix S2 problem

Andre mythtv-list at dinkum.org.uk
Fri Jan 7 09:27:12 UTC 2011


On 7 Jan 2011, at 00:00, Pangurban wrote:

> OK - This will seem slightly silly in light of what I replied but ....
> 
> Could anybody possibly tell me how to get the ngene_18.fw to load at
> bootup in preference to the v 1.5?

I believe the firmware version loaded is the one the driver requests, there is no way to control this beyond using the different driver.

[    8.790369] nGene PCIE bridge driver, Copyright (C) 2005-2007 Micronas
[    8.795102] ACPI: PCI Interrupt Link [APC8] enabled at IRQ 16
[    8.795110] ngene 0000:04:00.0: PCI INT A -> Link[APC8] -> GSI 16 (level, low) -> IRQ 16
[    8.796795] ngene: Found Mystique SaTiX-S2 Dual (v2)
[    8.801791] ngene 0000:04:00.0: setting latency timer to 64
[    8.801928] ngene: Device version 1
[    8.801951] ngene 0000:04:00.0: firmware: requesting ngene_18.fw
[    8.881812] ngene: Loading firmware file ngene_18.fw.


If your system is loading ngene_15.fw then I suspect you are not actually using the new driver!

H'mm the page I linked to doesn't mention depmod, maybe it's done in make install but maybe not.

Perhaps you need: 
sudo depmod -a
to ensure the newly compiled driver is used.

Andre
> 
> 
> On 05/01/2011 22:58, Pangurban wrote:
>> 
>> On 05/01/2011 16:47, Andre wrote:
>>> Hi, not a good subject line, I changed it for you :-) I only saw this
>>> because I have some search rules for things with the Satix S2 card!
>>> 
>> Thank you very much Andre
> Regards,
> 
> Brian – In Ireland
> 
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
> 



More information about the mythtv-users mailing list